MTW Inferno Red Nozzle V2

15,90

(2 customer reviews)

Upgrade nozzle for the Wolverine MTW Inferno engine for better BB placement, improved accuracy!

In stock

Category: SKU: SI-MTWINF-RED-NOZZLE

Description

The most important part when it comes to accuracy in HPA is the correct BB placement, we found out that the stock MTW nozzle can be made longer to further improve the BB placement in the hop-up chamber!

This is why we made the Silent Industries MTW Inferno “Red” nozzle V2!

Whats new with the V2?

  • Multi Material design
  • Less friction in the hop-up chamber due to the POM plastic nozzle tip
  • Little bit shorter while maintaining the same BB placement, this results in improved feeding (not noticeable in most cases)

Key features:

  • Improved BB placement, resulting in better accuracy. Depending on the setup, it can be very significant.
  • Tapered nozzle end, ensures perfect seal with the bucking, POM Plastic end has reduced friction in the Hop-Up
  • High-grade 7075 aluminum and Self Lubricating Hard POM plastic
  • Red anodized color, matches with the Inferno body

Short nozzles can cause vertical deviation between shots, when upgrading to this nozzle, you can expect less vertical inaccuracy!

Comes with a 5×1 O-ring for sealing with the nozzle base

To install you will need a 8mm wrench and a 5mm hex-key !

Works with Stock MTW, Phoenix and Alpha chamber!

M4W is not tested, works for some users, but not guaranteed

Only for Inferno engines! Does not work with Reaper engines!

If you have a Red nozzle V1, upgrade is not a must!

 

 

 

Disclaimer: All aftermarket upgrade parts require necessary skill or modification to install and assemble, please consult with your airsoft technician if needed. This part is only for toys.

Brand

Silent Industries

2 reviews for MTW Inferno Red Nozzle V2

  1. K9Rayne (verified owner)

    Purchased and installed into my replica and was surprised on different levels. First was the fact that I was expecting to have a greater FPS or Joules increase using the same 110psi I use regularly with .36g, but that didn’t seem to be the case. My FPS and Joules were very close to the factory nozzle. However, after the first few shots after install the .36’s seemed to take a massive hike right out of the barrel which was worse then stock. Adjusted my hop down to like 3.5-4 and the replica came to life!!!!! Consistent lazer beam BBs which was a 1000% increase over the factory nozzle. With the 6.01 inner barrel I was shooting straighter and more consistent “on target” hits. I am very impressed with the CNC nozzle and definitely recommend it to every MTW owner.

  2. Eric beck

    Grate product when I installed it I was thinking I would have to adjust my reg but it maintains the same joules on the crono and gave my range a pretty big boost however long rang groupings are pretty wide but I think that’s because I’m still running a stock barrle and hop unit I’m excited to see what this dose with a upgraded barrel and the alpha hop unit

Add a review

Your email address will not be published. Required fields are marked *

Post comment

You may also like…